Then pull the air intake hose free and set it aside. Do the same thing to this hose clamp right here. Then loosen up this hose clamp for your 8mm socket and ratchet. Start off by pushing on this tab and pulling this hose free. The items you'll need for this are a new cam shift position sensor from, and an 8mm socket and ratchet. It's the same part and similar part on these F150s with this engine from 2000 to 2005. Thanks! In this video, we're going to show you how to replace the cam shaft position sensor on this 2005 Ford F150 with the 4.6-liter V8 engine. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of. Install the EGR valve and adapter assembly.Brought to you by, your source for quality replacement parts and the best service on the Internet.NOTE: During installation, the arrow on the synchronizer alignment tool will rotate clockwise as the gears engage. Install the camshaft synchronizer housing assembly so the arrow on the Syncro Positioning Tool is 54 degrees from the centerline of the engine.NOTE: Rotate crankshaft to #1 cylinder TDC on compression stroke. Install the camshaft synchronizer housing assembly as shown.Rotate the Syncro Positioning Tool until it engages the notch in the camshaft synchronizer housing.Install the Syncro Positioning Tool on the camshaft synchronizer.Failure to follow this procedure will result in the fuel system being out of time with the engine, possibly causing engine damage. INSTALLATION CAUTION: The Syncro Positioning Tool must be obtained prior to installation of the replacement camshaft synchronizer assembly. The oil pump drive shaft may come out with the camshaft synchronizer.Remove the camshaft synchronizer adjustment bolt.Remove the EGR valve and adapter assembly.Remove the Exhaust Gas Recirculation (EGR) valve vacuum hose.Remove the Camshaft Position Sensor ( CMP sensor).Follow the removal procedure in reverse order.Remove the camshaft position sensor from the camshaft synchronizer.Remove the Camshaft Position sensor ( CMP sensor).Disconnect the CMP sensor electrical connector.ĬAUTION: Do not turn the crankshaft or camshaft during the removal and installation procedure or the fuel system control will be out of time with the engine and possibly cause engine damage.Position the heater water outlet tube aside.Remove the heater water outlet tube bolt.Disconnect the fuel charging wiring harness from the heater water outlet tube.Disconnect the heater water outlet tube.
0 kommentar(er)
